— Inteligentní osvětlení / Inteligent friendly light

Support

1. Connect the Immax NEO smart control centre to a power supply and, using the supplied network cable, connect to your Wi-Fi router. Wait a few seconds for all the control lights on the Immax NEO smart control centre to light up.

2. Using the attached QR code, download and install the Immax NEO app

YOU ARE NOW READY TO BECOME A MASTER OF LIGHT IN YOUR OWN HOME.

FREQUENTLY ASKED QUESTIONS

  1. An Immax NEO light is not responding to remote control.

Possible causes:

The Immax NEO light and the remote control are not properly paired. Pair the remote control with the light according to the instruction manual.

Check whether there are batteries in the remote control or whether the batteries are charged.

The distance between the Immax NEO light and the remote control is too great, or the signal reception is being blocked or limited by obstacles. Try moving the remote control closer to the Immax NEO light.

  1. An Immax NEO light is not responding to the remote control, even though the causes under item 1. have been ruled out

Possible causes:

The software of the Immax NEO smart control centre is blocked due to the rapid entry of too many commands via the remote control. Disconnect the Immax NEO light from the power supply, reconnect it and reset it. Then try pairing the light with the remote control again.

The Immax NEO light, the smart control centre and the remote control are not connected to the same Wi-Fi network. Connect the remote control to the same network used by the smart control centre.

  1. After being connected to a power supply, an Immax NEO light does not turn on.

Possible causes:

Check the connection of the lighting fixture. Make sure that the light is properly connected to the mains network. Check the fuses in the distribution board. Check that the wall-mounted light switch is not in the Off position.

Do not connect an Immax NEO light to an existing dimmer switches installed in your home.

Do not connect an Immax NEO light to an existing timer switches or motion sensors installed in a particular lighting network. Set timer switches for more than 10 seconds. This way, you will keep lamps from resetting (returning to factory settings) unintentionally.

  1. How do I reset an Immax NEO remote control?

Hold down the W button on the remote control for more than 3 seconds. Then press the On/Off button. The remote control should be returned to factory settings.

  1. How do I reset an Immax NEO light?

Using the Immax NEO remote control: position the remote control near to the light source (within 30 cm), then successively press the buttons 1, +, 2, -, 3 and N. After being returned to factory settings, the light will begin to flash.

You can now reset the light by turning it on and off 5 times.